HP 7000 dl Router manual Ping address, Address

SROS Command Line Interface Reference Guide Basic Mode Command Set

ping <address>

Use the ping command (at the Basic Command Mode prompt) to verify IP network connectivity.

Syntax Description

<address>	Optional. Specifies the IP address of the system to ping. Entering the ping command
	with no specified address prompts the user with parameters for a more detailed ping
	configuration. See Functional Notes (below) for more information.

Default Values

No default value necessary for this command.

Command Modes

> or # Basic or Enable Command Mode

Functional Notes

The ping command helps diagnose basic IP network connectivity using the Packet InterNet Groper program to repeatedly bounce Internet Control Message Protocol (ICMP) Echo_Request packets off a system (using a specified IP address). The Secure Router OS allows executing a standard ping request to a specified IP address or provides a set of prompts to configure a more specific ping configuration.

The following is a list of output messages from the ping command:

!

Success

-

Destination Host Unreachable

$

Invalid Host Address

X

TTL Expired in Transit

?

Unknown Host

*

Request Timed Out

The following is a list of available extended ping fields with descriptions:

Target IP address:

Specifies the IP address of the system to ping.

Repeat Count:

Number of ping packets to send to the system (valid range: 1 to 1000000).

Datagram Size:

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 13