HP 7000 dl Router manual Copyright 2005 Hewlett-Packard Development Company, L.P 926

Common Commands

(config-fr 7)#interface fr 7.22

(config-fr7.22)#frame-relay interface-dlci 30

(config-fr 7.22)#ip address 193.44.69.253 255.255.255.252

Step 3:

Specify the group of DS0s used for signaling on the T1 interface by creating a tdm-group. Group any number of contiguous DS0s together to create a data pipe for layer 2 signaling. Also use the tdm-groupcommand to specify the per-DS0 signaling rate on the interface. For example, the following creates a tdm-group labeled 9 containing 20 DS0s (each DS0 having a data rate of 56 kbps).

(config)#interface t1 1/1

(config-t11/1)#tdm-group 9 timeslots 1-20 speed 56 (config-t1 1/1)#exit

Step 4:

Make the association between the layer 2 endpoint and the physical interface using the bind command. Supported layer 2 protocols include Frame Relay and point-to-point protocol (PPP). For example, the following creates a bind (labeled 5) to make an association between the Frame Relay virtual interface (fr 7) and the tdm-group configured on interface t1 1/1 (tdm-group 9).

(config)#bind 5 t1 1/1 9 fr 7

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 926