HP 7000 dl Router manual Modem Interface Configuration Command SET

SROS Command Line Interface Reference Guide Modem Interface Configuration Command Set

MODEM INTERFACE CONFIGURATION COMMAND SET

To activate the Modem Interface Configuration , enter the interface modem command at the Global Configuration Mode prompt. For example:

Router>enable

Router#configure terminal

Router(config)#interface modem 1/2

Router(config-modem 1/2)#

The modem interface number in the example above is shown as modem 1/2. This number is based on the interface’s location (slot/port) and could vary depending on the unit’s

Note configuration. Use the do show interfaces command to determine the appropriate interface number.

The following commands are common to multiple command sets and are covered in a centralized section of this guide. For more information, refer to the sections listed below:

alias <“text”> on page 923

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924 description on page 927

do on page 928 end on page 929 exit on page 930 shutdown on page 935

All other commands for this command set are described in this section in alphabetical order.

caller-id override [always <number> if-no-cid <number>] on page 553

dialin on page 554

modem countrycode <countryname> on page 555

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 552