HP 7000 dl Router manual Assign a simple-text authentication password to be used by

SROS Command Line Interface Reference Guide Loopback Interface Configuration Command Set

ip ospf

Use the ip ospf command to customize OSPF settings (if needed).

Syntax Description

authentication-key	Assign a simple-text authentication password to be used by
	other routers using <password>the OSPF simple password
	authentication.
cost <value>	Specify the OSPF cost of sending a packet on the interface.
	This value overrides any computed cost value. Range:
	1-65535.
dead-interval <seconds>	Set the maximum interval allowed between hello packets. If
	the maximum is exceeded, neighboring devices will
	determine that the device is down.
	Range: 0-32767.
hello-interval <seconds>	Specify the interval between hello packets sent on the
	interface. Range: 0-32767.
	message-digest-key <keyid> md5 <key>Configure OSPF
	Message Digest 5 (MD5) authentication (16-byte max) keys.
priority <value>	Set the OSPF priority. The value set in this field helps
	determine the designated router for this network. Range:
	0-255.
retransmit-interval <seconds>	Specify the time between link-state advertisements (LSAs).
	Range: 0-32767.
transmit-delay <seconds>	Set the estimated time required to send an LSA on the
	interface. Range: 0-32767.

Default Values

retransmit-interval <seconds> 5 seconds

transmit-delay <seconds>	1 second
hello-interval <seconds>	10 seconds: Ethernet, point-to-point, Frame Relay, and ppp
dead-interval <seconds>	40 seconds

Command Modes

(config-interface)#	Valid interfaces include: Ethernet (eth 0/1), virtual Frame Relay (fr 1), and virtual
	PPP (ppp 1).

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 865