HP 7000 dl Router manual Bridge-group group#, Config#interface hdlc 1 config-hdlc1#bridge-group

SROS Command Line Interface Reference Guide HDLC Command Set

bridge-group <group#>

Use the bridge-groupcommand to assign an interface to the specified bridge group. Use the no form of this command to remove the interface from the bridge group.

Syntax Description

<group#>	Specifies bridge group number (1 to 255) specified using the bridge-group
	command

Default Values

By default, there are no configured bridge groups.

Command Modes

(config-interface)#	Interface Configuration Mode
	Valid interfaces include: Ethernet (eth 0/1), virtual PPP interfaces (ppp 1), virtual
	HDLC interfaces (hdlc 1), virtual Frame Relay sub-interfaces (fr 1.20), tunnel
	interfaces (tunnel 1), and VLAN interface (vlan 1).

Functional Notes

A bridged network can provide excellent traffic management to reduce collisions and limit the amount of bandwidth wasted with unnecessary transmissions when routing is not necessary. Any two interfaces can be bridged (Ethernet to T1 bridge, Ethernet to Frame Relay sub-interface, etc.).

Usage Examples

The following example assigns the HDLC interface labeled 1 to bridge-group 1:

(config)#interface hdlc 1 (config-hdlc1)#bridge-group 1

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 817