HP 7000 dl Router manual Copyright 2005 Hewlett-Packard Development Company, L.P 605

SROS Command Line Interface Reference Guide Frame Relay Sub-Interface Config Command Set

backup backup-delay <seconds>

Use the backup backup-delaycommand to configure the amount of time the router will wait after the failure condition is recognized before attempting to backup the link. Use the no form of this command to return to the default value.

Syntax Description

<seconds>	Specifies the delay period (in seconds) a failure must be active before the Secure
	Router OS will enter backup operation on the interface (valid range: 10 to 86400
	seconds)

Default Values

<seconds> 10 seconds

Command Modes

(config-fr 1.16)# Virtual Frame Relay Sub-Interface Configuration Mode required

Usage Examples

The following configures the Secure Router OS to wait 60 seconds (on an endpoint with an active alarm condition) before attempting backup operation:

(config)#interface frame-relay 1.16 (config-fr 1.16)#backup backup-delay 60

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 605