HP 7000 dl Router manual Quality of Service QOS MAP Commands, Quality of Service QoS Map Commands

Quality of Service (QoS) Map Commands

QUALITY OF SERVICE (QOS) MAP COMMANDS

A QoS policy is defined using a QoS map in the CLI. The QoS map is a named list with sequenced entries. An entry contains a single match reference and one or more actions (priority, set, or both). To activate the QoS Command Set (which allows you to create and/or edit a map), enter a valid version of the QoS command at the Global Configuration Mode prompt. Multiple map entries for the same QoS map are differentiated by a sequence number. The sequence number is used to assign match order.

Once created, a QoS map must be applied to an interface (using the qos-policy out <map-name>command) in order to actively process traffic. Any traffic for the interface that is not sent to the priority queue is sent using the default queuing method for the interface (such as weighted fair queuing).

For example:

>enable

#config terminal

(config)#qos map VOICEMAP 10 (config-qos-map)#match precedence 5 (config-qos-map)#priority 512 (config-qos-map)#exit(config)#interface fr 1

(config-fr1)#qos-policy out VOICEMAP

The following commands are common to multiple command sets and are covered in a centralized section of this guide. For more information, refer to the sections listed below:

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924

do on page 928 end on page 929 exit on page 930

ping <address> on page 931 show running-configon page 933

All other commands for this command set are described in this section in alphabetical order.

match on page 918 priority on page 919

set dscp <0-63>on page 920

set precedence <0-7>on page 921

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 917