HP 7000 dl Router manual IKE Policy Command SET, IKE Policy Command Set

SROS Command Line Interface Reference Guide IKE Policy Command Set

IKE POLICY COMMAND SET

To activate the IKE Policy , enter the crypto ike policy command at the Global Configuration Mode prompt. For example:

Router>enable

Router#configure terminal

Router(config)#crypto ike policy 1

Router(config-ike)#

The following commands are common to multiple command sets and are covered in a centralized section of this guide. For more information, refer to the sections listed below:

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924 do on page 928

end on page 929 exit on page 930

ping <address> on page 931 show running-configon page 933

All other commands for this command set are described in this section in alphabetical order.

attribute <policynumber> on page 374 client authentication host on page 375

client authentication server list <listname> on page 377 client configuration pool <poolname> on page 378 initiate [main aggressive] on page 379

local-id [address asn1-dn fqdn user-fqdn] <ipaddress or name> on page 380 nat-traversal <version> [allow disable force] on page 382

peer [<ip address> any] on page 383

respond [main aggressive anymode] on page 385

Note	For VPN configuration example scripts, refer to the VPN Configuration Guide located on
	the ProCurve SROS Documentation CD provided with your unit.

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 373