HP 7000 dl Router manual Bandwidth, Config#interface tunnel 1 config-tunnel 1#bandwidth

Command Reference Guide Tunnel Configuration Command Set

bandwidth

Use the bandwidth command to provide the bandwidth value of an interface to the higher-level protocols. This value is used in cost calculations. Use the no form of this command to restore the default values.

Syntax Description

<value> Specifies bandwidth in kbps.

Default Values

To view default values, use the show interfaces command.

Command Modes

(config-interface)#	Interface Configuration Mode
	Valid interfaces include: Ethernet (eth 0/1), PPP virtual interfaces (ppp 1), HDLC
	virtual interfaces (hdlc 1), Frame Relay virtual sub-interfaces (fr 1.20), tunnel
	interfaces (tunnel 1), and VLAN interface (vlan 1).

Functional Notes

The bandwidth command is an informational value that is communicated to the higher-level protocols to be used in cost calculations. This is a routing parameter only and does not affect the physical interface.

Usage Examples

The following example sets bandwidth of the tunnel 1 interface to 10 Mbps:

(config)#interface tunnel 1 (config-tunnel 1)#bandwidth 10000

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 782