HP 7000 dl Router Copy xmodem destination, #copy xmodem flash Destination filename newfile.biz

SROS Command Line Interface Reference Guide Enable Mode Command Set

copy xmodem <destination>

Use the copy xmodem command to copy a file (using the XMODEM protocol) to a specified destination. XMODEM capability is provided in terminal emulation software such as HyperTerminal™.

Syntax Description

<destination>	Specifies the destination of the copied file.
	Valid destinations include: flash (FLASH memory), startup-config(the
	configuration file stored in NVRAM), or running-config(the current running
	configuration file).
	After entering copy xmodem and specifying a destination, the Secure Router OS
	prompts for the following information:
Destination filename:	Specifies the filename to use when storing the copied file to FLASH memory.
	(Valid only for the copy flash command.)

Default Values

No default value necessary for this command.

Command Modes

# Enable Command Mode

Usage Examples

The following example copies a .biz file to flash memory and labels it newfile.biz:

#copy xmodem flash Destination filename newfile.biz

Begin the Xmodem transfer now...

Press CTRL+X twice to cancel

CCCCCC

The Secure Router OS is now ready to accept the file on the CONSOLE port (using the XMODEM protocol). The next step in the process may differ depending on the type of terminal emulation software you are using. For HyperTerminal, you will now select Transfer > Send File and browse to the file you wish to copy. Once the transfer is complete, information similar to the following is displayed:

Received 231424 bytes.

Transfer complete.

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 59