HP 7000 dl Router manual IKE Policy Attributes Command SET, IKE Policy Attributes Command Set

SROS Command Line Interface Reference Guide IKE Policy Attributes Command Set

IKE POLICY ATTRIBUTES COMMAND SET

To activate the IKE Policy Attributes , enter the attribute command at the IKE Policy prompt. For example:

Router>enable

Router#configure terminal

Router(config)#crypto ike policy 1

Router(config-ike)#attribute10

Router(config-ike-attribute)#

The following commands are common to multiple command sets and are covered in a centralized section of this guide. For more information, refer to the sections listed below:

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924 do on page 928

end on page 929 exit on page 930

ping <address> on page 931 show running-configon page 933

All other commands for this command set are described in this section in alphabetical order.

authentication [dss-sig pre-share rsa-sig]on page 387 encryption [aes-xxx-cbc des 3des] on page 388 group [1 2] on page 389

hash [md5 sha] on page 390 lifetime <seconds> on page 391

Note	For VPN configuration example scripts, refer to the VPN Configuration Guide located on
	the ProCurve SROS Documentation CD provided with your unit.

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 386