HP 7000 dl Router manual Sets the network type for broadcast

Command Reference Guide Tunnel Configuration Command Set

ip ospf network [broadcast point-to-point]

Use the ip ospf network command to specify the type of network on this interface.

Syntax Description

broadcast	Sets the network type for broadcast.
point-to-point	Sets the network type for point-to-point.

Default Values

By default, Ethernet defaults to broadcast. PPP, Frame Relay, and tunnel default to point-to-point.

Command Modes

(config-interface)#	Interface Configuration Mode
	Valid interfaces include: Ethernet (eth 0/1), PPP virtual interfaces (ppp 1), HDLC
	virtual interfaces (hdlc 1), Frame Relay virtual sub-interfaces (fr 1.20), tunnel
	interfaces (tunnel 1), and VLAN interface (vlan 1).

Functional Notes

A point-to-point network will not elect designated routers.

Usage Examples

The following example designates a broadcast network type:

(config)#interface tunnel 1 (config-tunnel 1)#ip ospf network broadcast

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 798