HP 7000 dl Router manual BGP Configuration Command SET, BGP Configuration Command Set

SROS Command Line Interface Reference Guide BGP Configuration Command Set

BGP CONFIGURATION COMMAND SET

To activate the BGP Configuration, enter the bgp command at the Global Configuration Mode prompt. For example:

Switch>enable

Switch#configure terminal

Switch(config)#bgp

Switch(config-bgp)#

The following commands are common to multiple command sets and are covered in a centralized section of this guide. For more information, refer to the sections listed below:

description on page 927 exit on page 930

All other commands for this command set are described in this section in alphabetical order.

bgp fast-external-falloveron page 706 bgp log-neighbor-changeson page 707 bgp router-id <ip address> on page 708

distance bgp <external> <internal> <local> on page 709 hold-timer <hold time> on page 710

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 705