HP 7000 dl Router manual Copyright 2005 Hewlett-Packard Development Company, L.P 185

SROS Command Line Interface Reference Guide Enable Mode Command Set

show snmp

Use the show snmp command to display the system Simple Network Management Protocol (SNMP) parameters and current status of SNMP communications.

Syntax Description

No subcommands.

Default Values

No default value necessary for this command.

Command Modes

> or # Basic or Enable Command Mode

Usage Examples

The following is an example output using the show snmp command for a system with SNMP disabled and the default Chassis and Contact parameters:

>show snmp

Chassis: Chassis ID

Contact: Customer Service 0 Rx SNMP packets

0 Bad community names

0 Bad community uses

0 Bad versions

0 Silent drops

0 Proxy drops

0 ASN parse errors

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 185