Command Reference Guide

Tunnel Configuration Command Set

 

 

ip rip send version [1 2]

Use the ip rip send version command to configure the RIP version the unit sends in all RIP packets transmitted on the interface. Use the no form of this command to restore the default value.

Syntax Description

1

Only transmits RIP version 1 packets on the interface.

2

Only transmits RIP version 2 packets on the interface.

Default Values

By default, all interfaces transmit RIP version 1 (the default value for the version command).

Command Modes

(config-interface)#

Interface Configuration Mode

 

Valid interfaces include: Ethernet (eth 0/1), PPP virtual interfaces (ppp 1), HDLC

 

virtual interfaces (hdlc 1), Frame Relay virtual sub-interfaces (fr 1.20), tunnel

 

interfaces (tunnel 1), and VLAN interface (vlan 1).

Functional Notes

Use the ip rip send version command to specify a RIP version that overrides the version (in the Router RIP) configuration. See version <version> on page 902 for more information.

The SROS only transmits one version (either 1 or 2) on a given interface.

Usage Examples

The following example configures the tunnel interface to transmit only RIP version 2 packets:

(config)#interface tunnel 1 (config-tunnel 1)#ip rip send version 2

5991-2114

© Copyright 2005 Hewlett-Packard Development Company, L.P.

801

Page 801
Image 801
HP 7000 dl Router manual Ip rip send version 1, Only transmits RIP version 1 packets on the interface