SROS Command Line Interface Reference Guide Frame Relay Sub-Interface Config Command Set

ip route-cache <address>

Use the ip route-cachecommand to enable fast-cache switching on the interface. Use the no form of this command to disable fast-cache switching and return to process switching mode.

Note

Using Network Address Translation (NAT) or the Secure Router OS firewall capabilities on

an interface requires process switching mode (using the no ip route-cachecommand).

 

 

 

Syntax Description

No subcommands.

Default Values

By default, fast-cache switching is enabled on all Ethernet and virtual Frame Relay sub-interfaces. IP route-cache is enabled for all virtual PPP interfaces.

Command Modes

(config-interface)#

Interface Configuration Mode required

 

Valid interfaces include: Ethernet (eth 0/1), virtual Frame Relay sub-interfaces (fr

 

1.16), and virtual PPP interfaces (ppp 1).

Functional Notes

Fast switching allows an IP interface to provide optimum performance when processing IP traffic.

Usage Examples

The following example enables fast switching on a Frame Relay sub-interface:

(config)#interface frame-relay 1.16 (config-fr 1.16)#ip route-cache

5991-2114

© Copyright 2005 Hewlett-Packard Development Company, L.P.

635

Page 635
Image 635
HP 7000 dl Router manual Ip route-cache address