SROS Command Line Interface Reference Guide

Crypto Map IKE Command Set

 

 

CRYPTO MAP IKE COMMAND SET

To activate the Crypto Map IKE , enter a valid version of the crypto map ipsec-ikecommand at the Global Configuration Mode prompt. For example:

Router>enable

Router#configure terminal

Router(config)#crypto map Map-Name 10 ipsec-ike

Router(config-crypto-map)#

The following commands are common to multiple command sets and are covered in a centralized section of this guide. For more information, refer to the sections listed below:

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924 description on page 927

do on page 928 end on page 929 exit on page 930

ping <address> on page 931 show running-configon page 933

All other commands for this command set are described in this section in alphabetical order.

antireplay on page 397

ike-policy <policy number> on page 398 match address <listname> on page 399 set peer <address> on page 401

set pfs [group1 group2] on page 402

set security-association lifetime [kilobytes seconds] <value> on page 403 set transform-set <setname1 - setname6> on page 404

Note

ProCurve SROS Documentation CD

 

 

5991-2114

© Copyright 2005 Hewlett-Packard Development Company, L.P.

396

Page 396
Image 396
HP 7000 dl Router manual Crypto MAP IKE Command SET, Crypto Map IKE Command Set