HP 7000 dl Router manual Interface loopback label, Config#interface loopback

SROS Command Line Interface Reference Guide Global Configuration Mode Command Set

interface loopback <label>

Use the interface loopback command to create a virtual interface that can be assigned layer 3 and higher properties and is always up unless the router is shut down. Use the no form of this command to delete a configured loopback interface.

Syntax Description

<label>	Specifies the numerical virtual loopback interface identifying label (valid range:
	1 to 1024)

Default Values

By default, there are no configured loopback interfaces.

Command Modes

(config)# Global Configuration Mode required

Usage Examples

The following example creates a loopback virtual interface (labeled 1) and enters the Loopback Interface Configuration Mode:

(config)#interface loopback 1

(config-loop 1)#

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 245