HP 7000 dl Router manual Bridge-group group# bpdufilter enable disable

SROS Command Line Interface Reference Guide PPP Interface Configuration Command Set

bridge-group <group#> bpdufilter [enable disable]

Use the bridge-group bpdufilter command to block BPDUs from being transmitted and received on this interface. To return to the default value, use the no form of this command.

Syntax Description

<group#>	Bridge group number (1 to 255) specified using the bridge-groupcommand.
enable	Enable the BPDU filter.
disable	Disable the BPDU filter.

Default Values

By default, this command is set to disable.

Command Modes

(config-interface)#	Interface Configuration Mode
	Valid interfaces include: Ethernet (eth 0/1), virtual PPP interfaces (ppp 1), and
	virtual Frame Relay sub-interfaces (fr 1.20)

Functional Notes

The purpose of this command is to remove a port from participation in the spanning-tree. This might be beneficial while debugging a network setup. It normally should not be used in a live network.

Usage Examples

The following example enables the bpdufilter on the interface:

(config)#interface ppp 1

(config-ppp1)#bridge-group 1 bpdufilter enable

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 726