HP 7000 dl Router manual Show interfaces interface, Total-24-hourintervals

SROS Command Line Interface Reference Guide Enable Mode Command Set

show interfaces <interface>

Use the show interfaces command to display configuration parameters and current statistics for all interfaces (or a specified interface).

Syntax Description

<interface>	Optional. Specific interface to display. Type show interfaces ? for a complete
	list of valid interfaces.

performance-statisticsOptional. Displays the current 15-minute interval, the current 24-hour totals, and all 96 stored intervals.

performance-statisticsOptional. Displays the current 24-hour totals and the past seven 24-hour

total-24-hourintervals.

performance-statisticsShows the current 15-minute interval, the current 24-hour totals, and all intervals

<x-y>	from x through y. This command is basically the same thing as the
	performance-statisticscommand with the added function of allowing you to
	specify a particular interval (or range of intervals) to display rather than displaying
	all 96.
	Note: If you wish to display the 24th interval, enter (for example) show interface
	shdsl 1/1 performance-statistics 24-24. Entering show interface shdsl 1/1
	performance-statistics 24 results in displaying the 24-hour statistics. Any
	number other than 24 (between 1 and 96) results in the correct display of the
	selected interval (e.g., show interface shdsl 1/1 performance-statistics 4
	shows the 4th interval).
switchport	Summary of the Layer 2 information for Ethernet connections.
version	Optional. Displays current version information (e.g., model and list number,
	software version, etc.) for the SHDSL interface.

Default Values

No default value necessary for this command.

Command Modes

# Enable Command Mode

Usage Examples

The following are samples from various show interfaces commands:

>enable

#show interfaces t1 1/1

t1 1/1 is UP

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 132