HP 7000 dl Router manual Coding ami b8zs, Config#interface t1 1/2 config-t1 1/2#coding ami

SROS Command Line Interface Reference Guide DSX-1 Interface Configuration Command Set

coding [ami b8zs]

Use the coding command to configure the line coding for a T1 or DSX-1 physical interface. This setting must match the line coding supplied on the circuit by the PBX.

Syntax Description

ami	Configures the line coding for alternate mark inversion.
b8zs	Configures the line coding for bipolar eight zero substitution.

Default Values

By default, all T1 interfaces are configured with B8ZS line coding.

Command Modes

(config-t1 1/1)#	T1 or DSX-1 Interface Configuration Mode required.
(config-t1 1/2)#

Functional Notes

The line coding configured in the unit must match the line coding of the T1 circuit. A mismatch will result in line errors (e.g., BPVs).

Usage Examples

The following example configures the DSX-1 interface for AMI line coding:

(config)#interface t1 1/2 (config-t1 1/2)#coding ami

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 521