HP 7000 dl Router manual Following example sets the helper address as the Igmp proxy

Command Reference Guide Tunnel Configuration Command Set

ip mcast-stub helper-enable

Use the ip mcast-stub helper-enable command to assign the ip mcast-stub helper-address as the IGMP proxy. Use the no form of this command to disable.

Syntax Description

No subcommands.

Default Values

By default, this command is disabled.

Command Modes

(config-interface)#	Interface Configuration Mode
	Valid interfaces include: Ethernet (eth 0/1), PPP virtual interfaces (ppp 1), HDLC
	virtual interfaces (hdlc 1), Frame Relay virtual sub-interfaces (fr 1.20), tunnel
	interfaces (tunnel 1), and VLAN interface (vlan 1).

Functional Notes

This command is used in IP multicast stub applications in conjunction with the ip mcast-stubhelper-address, ip mcast-stub upstream, and ip mcast-stub downstream commands. When enabled, the interface becomes a helper forwarding interface. The IGMP host function is dynamically enabled and the interface becomes the active upstream interface, enabling the unit to perform as an IGMP proxy. Refer to ip mcast-stubhelper-address <ip address> on page 389, ip mcast-stub downstream on page 791, and ip mcast-stub upstream on page 794 for more information.

Usage Examples

The following example sets the helper address as the IGMP proxy:

(config)#interface tunnel 1

(config-tunnel 1)#ip mcast-stub helper-enable

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 793