HP 7000 dl Router manual Show ip interfaces interface brief, Brief, Enable #show ip interfaces

SROS Command Line Interface Reference Guide Enable Mode Command Set

show ip interfaces [<interface> brief]

Use the show ip interfaces command to display the status information for all IP interfaces (or a specific interface).

Syntax Description

<interface>	Optional. Enter a specific interface to view its status information. If no interface is
	entered, status information for all interfaces is displayed. Type show ip interfaces ?
	for a complete list of applicable interfaces.
brief	Use this optional keyword to display an abbreviated version of interface statistics
	for all IP interfaces.

Default Values

No default value necessary for this command.

Command Modes

# Enable Command Mode

Usage Examples

The following is a sample output of the show ip interfaces command:

>enable

#show ip interfaces

eth 0/1 is UP, line protocol is UP Ip address is 10.10.10.1 Netmask is 255.255.255.0 MTU is 1500

Fastcaching is Enabled

RIP Authentication is Disabled RIP Tx uses global version value RIP Rx uses global version value

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 151