HP 7000 dl Router manual Traceroute address, Enable #traceroute

SROS Command Line Interface Reference Guide Enable Mode Command Set

traceroute <address>

Use the traceroute command to display the IP routes a packet takes to reach the specified destination.

Syntax Description

<address> Optional. Specifies the IP address of the remote system to trace the routes to.

Default Values

No default value necessary for this command.

Command Modes

> or # Basic or Enable Command Mode

Usage Examples

The following is a sample traceroute output:

>enable

#traceroute 192.168.0.1

Type CTRL+C to abort.

Tracing route to 192.168.0.1 over a maximum of 30 hops

1	22ms	20ms	20ms	192.168.0.65
2	23ms	20ms	20ms	192.168.0.1

#

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 196