Getting Acquainted with the System
Standby
TANDBERG 1700 MXP USER GUIDE
About Standby
The system will automatically go to Standby Mode when it is not in use. In Standby Mode, the screen(s) will turn black. It is, however, still possible to receive incoming calls.
The Standby Mode of the system should be enabled if the system is to be left idle.
To Enable Immediate Standby Mode
Press OK and navigate to the | Navigate to the Standby now icon | The system will now enter Standby |
Standby icon. Select Standby from | and click OK. | Mode immediately. |
the menu and click OK. |
|
|
Leaving Standby Mode | To Enable Delay Standby Mode for 1 Hour |
When the system is in Standby, pick up the remote control, or press any of its keys to activate the system again.
Note! Standby is not activated by switch- ing off the power to the monitor(s) (some systems come with monitors that are not possible to switch off.).
Tip! If the system is set for Use screen as Local PC monitor, see Control Panel > Screen Set- tings, the Standby mode will be disabled when the codec detects a video signal from the PC. When the PC video signal no longer is de- tected, the standby mode will be
Press OK/Menu and navigate to the | Navigate to the Delay Standby for 1 | The system will enter Standby Mode |
Standby icon. Select Standby from | hour icon and click OK. | in 1 hour from now. |
the menu and click OK. |
|
|
To Enable Delay Standby Mode for 3 Hours
Press OK/Menu and navigate to the | Navigate to the Delay Standby for 3 | The system will enter Standby Mode |
Standby icon. Select Standby from | hours icon and click OK. | in 3 hours from now. |
the menu and click OK. |
|
|
D 13954.01 | 23 |
JUNE 2006 |
