Control Panel > Network Settings > LAN Settings
H.323 Settings (IV) – Advanced NAT Settings
TANDBERG 1700 MXP USER GUIDE
About Network Address Translation (nat)
NAT, Network Address Translation, is used when a PC and a videoconferencing system are connected to a router with NAT support. NAT support in the videoconferencing system enables proper exchange of audio/video data when connected to an external videoconferencing system (when the IP traffic goes through a NAT router). When NAT is On, the NAT Server Address will be shown in the startup- menu: My IP Address: 10.0.2.1.
| NAT | NAT Address | |
On. The system will signal the configured | This must be the external/glo- | ||
“NAT Address” in place of its own | bal | ||
within Q.931 and H.245. | NAT support. Packets sent to | ||
Auto. The system will try to determine if the | the router will then be routed to | ||
the system. In the router, the | |||
“NAT Address” or the real | |||
following ports must be routed | |||
be used within signalling. This is done to | |||
to the system’s | |||
make it possible to place calls to endpoints | |||
• Port 1720 | |||
on the LAN as well as endpoints on the | |||
WAN. | • Port | ||
|
| • Port | |
|
| Please contact your TANDBERG | |
|
| representative for further infor- | |
|
| mation. | |
|
| RSVP | |
|
| ||
|
| Auto. Resource Reservation | |
|
| Protocol enables the systems to | |
|
| request the optimum amount of | |
|
| bandwidth for the duration of an | |
|
| IP videoconference. | |
|
| Off. Resource Reservation | |
|
| Protocol is switched off. | |
|
| H.323 Ports | |
The upper part of the menu is explained on | Static. When selecting static | ||
the preceding pages. | H.323 ports for TCP connec- | ||
|
| ||
|
| tions the ports 5555 to 5574 | |
CANCEL | will be used for Q.931 and | ||
H.245 respectively. | |||
Select this icon and press OK | |||
Dynamic. The system will al- | |||
to leave the menu undoing any | |||
changes. | locate which ports to use when | ||
RESTORE DEFAULTS | opening a TCP connection. | ||
The reason for doing this is | |||
Select this icon and press OK | |||
to avoid using the same ports | |||
to restore the default settings. | |||
for subsequent calls as some | |||
|
| ||
Save | firewall consider this as a sign | ||
Select this icon and press | of attack. | ||
OK to leave the menu putting |
| ||
changes into effect. |
|
Note! The Advanced H.323 Settings only have effect when supported by your IP infrastructure.
D 13954.01 | 115 |
MAY 2006 |