Control Panel > General Settings
Permissions
TANDBERG 1700 MXP USER GUIDE
What is MCU? MCU is short for Multipoint Conference Unit, a device used to connect multiple audio and video sites in one or more ISDN, IP and mixed ISDN and IP video meetings.
CANCEL
Select this icon and press OK to leave the menu undoing any changes.
RESTORE DEFAULTS
Select this icon and press OK to restore the default settings.
Save
Select this icon and press OK to leave the menu putting changes into effect.
Access Code
An access code will help you control the use of the sys- tem. All users must enter a code to identify themselves when making a call and the call may then be charged on their account. Access Codes are handy for group systems where there are more users or divisions that share the costs of using the system. Access Code can be set to On and Off. More on Access codes overleaf.
On When making a call, an Access Code dialogue box will be shown. The user must enter the correct password in order to put the call through.
Off No password is necessary to make a call.
Incoming MCU Calls
On When you are in a call, the system will provide visual and audible indications of additional incoming calls and ask you to accept/reject the call.
Off The system will not accept incoming calls when you are in a call.
Incoming Telephone Calls
On The system will accept incoming telephone calls.
Off The system will not accept incoming telephone calls. This may be used to prevent incoming calls from systems other than videoconferencing sys- tems.
Far End Camera Control
On The far end will be able to:
•Select your video sources
•Request snapshots
Off The far end can access none of the four features above on the local system. You will however still be able to control the camera on the far end.
Maximum Call Length (minutes)
This feature will automatically end both incoming and outgoing calls when the call time exceeds the speci- fied Maximum Call Length. Maximum Call Length can have the following values:
D 13954.01 | 67 |
MAY 2006 |