HP 7000 dl Router manual Copyright 2005 Hewlett-Packard Development Company, L.P 629

SROS Command Line Interface Reference Guide Frame Relay Sub-Interface Config Command Set

ip ospf

Use the ip ospf command to customize OSPF settings (if needed).

Syntax Description

authentication-key	Assign a simple-text authentication password to be used by other routers using
<password>	the OSPF simple password authentication.
cost <value>	Specify the OSPF cost of sending a packet on the interface. This value
	overrides any computed cost value. Range: 1-65535.
dead-interval <seconds>	Set the maximum interval allowed between hello packets. If the maximum is
	exceeded, neighboring devices will determine that the device is down. Range:
	0-32767.
hello-interval <seconds>	Specify the interval between hello packets sent on the interface. Range:
	0-32767.
message-digest-key	Configure OSPF Message Digest 5 (MD5) authentication (16-byte max) keys.
<keyid> md5 <key>
priority <value>	Set the OSPF priority. The value set in this field helps determine the designated
	router for this network. Range: 0-255.
retransmit-interval	Specify the time between link-state advertisements (LSAs). Range: 0-32767.
<seconds>
transmit-delay <seconds>	Set the estimated time required to send an LSA on the interface. Range:
	0-32767.

Default Values

retransmit-interval <seconds> 5 seconds

transmit-delay <seconds>	1 second
hello-interval <seconds>	10 seconds: Ethernet, point-to-point, Frame Relay, and ppp
dead-interval <seconds>	40 seconds

Command Modes

(config-interface)#	Valid interfaces include: Ethernet (eth 0/1), virtual Frame Relay (fr 1), and virtual
	PPP (ppp 1).

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 629