SROS Command Line Interface Reference Guide

PPP Interface Configuration Command Set

 

 

bridge-group <group#> edgeport [disable]

Use the bridge-group edgeport command to set this interface to be an edgeport. This configures the interface to go to a forwarding state when the link goes up. To return to the default value, use the no form of this command.

Syntax Description

<group#>

Bridge group number (1 to 255) specified using the bridge-groupcommand.

disable

Optional. Configure the interface to not be the edgeport by default. This command is

 

designed to override the global setting of the bridge <group#> protocol ieee on

 

page 211.

Default Values

By default, this command is set to disable.

Command Modes

(config-interface)#

Interface Configuration Mode

 

Valid interfaces include: Ethernet (eth 0/1), virtual PPP interfaces (ppp 1), and

 

virtual Frame Relay sub-interfaces (fr 1.20)

Usage Examples

The following example configures the interface to be an edgeport:

(config)#interface ppp 1

(config-ppp1)#bridge-group 1 edgeport

An individual interface can be configured to not be considered an edgeport. For example:

(config)#interface ppp 1

(config-ppp1)#bridge-group 1 edgeport disable

or

(config)#interface ppp 1

(config-ppp 1)#no bridge-group 1 edgeport

5991-2114

© Copyright 2005 Hewlett-Packard Development Company, L.P.

728

Page 728
Image 728
HP 7000 dl Router manual Bridge-group group# edgeport disable, Config#interface ppp Config-ppp1#bridge-group 1 edgeport