HP 7000 dl Router manual Enable #configure terminal Config#enable password password

SROS Command Line Interface Reference Guide Basic Mode Command Set

enable

Use the enable command (at the Basic Command Mode prompt) to enter the Enable Command Mode. Use the disable command to exit the Enable Command Mode. See the section enable on page 11 for more information.

Syntax Description

No subcommands.

Default Values

No default value necessary for this command.

Command Modes

>Basic Command Mode

Functional Notes

The Enable Command Mode provides access to operating and configuration parameters and should be password protected to prevent unauthorized use. Use the enable password command (found in the Global Configuration) to specify an Enable Command Mode password. If the password is set, access to the Enable Commands (and all other “privileged” commands) is only granted when the correct password is entered.

Usage Examples

The following example enters the Enable Command Mode and defines an Enable Command Mode password:

>enable

#configure terminal

(config)#enable password password

At the next login, the following sequence must occur:

>enable

Password: ******

#

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 11