HP 7000 dl Router manual Coding ami hdb3, Config#interface e1 1/2 config-e1 1/2#coding ami

SROS Command Line Interface Reference Guide G.703 Interface Configuration Command set

coding [ami hdb3]

Use the coding command to configure the line coding for the E1 or G.703 physical interface. This setting must match the line coding supplied on the circuit by the PBX.

Syntax Description

ami	Configures the line coding for alternate mark inversion.
hdb3	Configures the line coding for high-density bipolar 3.

Default Values

By default, all E1 interfaces are configured with HDB3 line coding.

Command Modes

(config-e1 1/1)#	E1 or G.703 Interface Configuration Mode required.
(config-e1 1/2)#

Functional Notes

The line coding configured in the unit must match the line coding of the E1 circuit. A mismatch will result in line errors (e.g., BPVs).

Usage Examples

The following example configures the G.703 interface for AMI line coding:

(config)#interface e1 1/2 (config-e1 1/2)#coding ami

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 546