HP 7000 dl Router manual Line Console Interface Config Command SET

SROS Command Line Interface Reference Guide Line (Console) Interface Config Command Set

LINE (CONSOLE) INTERFACE CONFIG COMMAND SET

To activate the Line (Console) Interface Configuration , enter the line console 0 command at the Global Configuration Mode prompt. For example:

Router> enable

Router#configure terminal

Router(config)#line console 0

Router(config-con 0)#

The following commands are common to multiple command sets and are covered in a centralized section of this guide. For more information, refer to the sections listed below:

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924 do on page 928

end on page 929 exit on page 930

ping <address> on page 931 show running-configon page 933

All other commands for this command set are described in this section in alphabetical order.

databits <option> on page 877

flowcontrol [none software in] on page 878 line-timeout <minutes> on page 879

login on page 880

login authentication <aaa login list> on page 881 login local-userliston page 882

parity <option> on page 883

password [md5] <password> on page 884 speed <rate> on page 885

stopbits <option> on page 886

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 876