HP 7000 dl Router manual Ip ospf

SROS Command Line Interface Reference Guide Ethernet Interface Configuration Command Set

ip ospf

Use the ip ospf command to customize OSPF settings (if needed).

Syntax Description

authentication-key	Assign a simple-text authentication password to be used by other routers using
<password>	the OSPF simple password authentication.
cost <value>	Specify the OSPF cost of sending a packet on the interface. This value
	overrides any computed cost value. Range: 1-65535.
dead-interval <seconds>	Set the maximum interval allowed between hello packets. If the maximum is
	exceeded, the neighboring device is assumed to be down. Range: 0-32767.
hello-interval <seconds>	Specify the interval between hello packets sent on the interface. Range:
	0-32767.
message-digest-key	Configure OSPF Message Digest 5 (MD5) authentication (16-byte max) keys.
<keyid> md5 <key>
priority <value>	Set the OSPF priority. The value set in this field helps determine the designated
	router for this network. Range: 0-255.
retransmit-interval	Specify the time between link-state advertisements (LSAs). Range: 0-32767.
<seconds>
transmit-delay <seconds>	Set the estimated time required to send an LSA on the interface. Range:
	0-32767.

Default Values

retransmit-interval <seconds>		5 seconds
transmit-delay <seconds>		1 second
hello-interval <seconds>		10 seconds: Ethernet, point-to-point, Frame Relay, and ppp
dead-interval <seconds>		40 seconds
Command Modes
(config-interface)#	Valid interfaces include: Ethernet, virtual Frame Relay (fr 1), and virtual PPP
	(ppp 1).

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 463