HP 7000 dl Router manual Config-interface# Interface configuration mode

SROS Command Line Interface Reference Guide E1 Interface Configuration Command Set

remote-loopback

Use the remote-loopbackcommand to configure the interface to accept loopback requests from a remote unit (or the service provider). Use the no form of this command to disable this feature.

Syntax Description

No subcommands.

Default Values

No default value is necessary for this command.

Command Modes

(config-interface)# Interface configuration mode.

Functional Notes

This controls the acceptance of any remote loopback requests. When enabled, remote loopbacks are detected and cause a loopback to be applied. When disabled, remote loopbacks are ignored.

Usage Examples

The following example enables remote loopbacks on the E1 interface:

(config)#interface e1 1/1

(config-e1 1/1)#remote-loopback

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 538