SROS Command Line Interface Reference Guide

IKE Client Command Set

 

 

IKE CLIENT COMMAND SET

To activate the IKE Client , enter the crypto ike client command at the Global Configuration Mode prompt. For example:

Router>enable

Router#configure terminal

Router(config)#crypto ike client configuration pool ConfigPool1 Router(config-ike-client-pool)#

The following commands are common to multiple command sets and are covered in a centralized section of this guide. For more information, refer to the sections listed below:

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924

do on page 928 end on page 929 exit on page 930

ping <address> on page 931 show running-configon page 933

All other commands for this command set are described in this section in alphabetical order.

dns-server <address1> <address2> on page 393 ip-range <start ip> <end ip> on page 394 netbios-name-server <address1> <address2> on page 395

Note

For VPN configuration example scripts, refer to the VPN Configuration Guide located on

the ProCurve SROS Documentation CD provided with your unit.

 

 

 

5991-2114

© Copyright 2005 Hewlett-Packard Development Company, L.P.

392

Page 392
Image 392
HP 7000 dl Router manual IKE Client Command SET, IKE Client Command Set