HP 7000 dl Router Router Ospf Configuration Command SET, Router Ospf Configuration Command Set

Router (OSPF) Configuration Command Set

ROUTER (OSPF) CONFIGURATION COMMAND SET

To activate the Router (OSPF) Configuration, enter the router ospf command at the Global Configuration Mode prompt. For example:

Router>enable

Router#configure terminal

Router(config)#router ospf

Router(config-ospf)#

The following commands are common to multiple command sets and are covered in a centralized section of this guide. For more information, refer to the sections listed below:

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924 do on page 928

end on page 929 exit on page 930

All other commands for this command set are described in this section in alphabetical order.

area <area id> default-cost <value> on page 904

area <area id> range <ip address> <network mask> [advertise not-advertise]on page 905 area <area id> stub [no-summary]on page 906

auto-costreference-bandwidth <rate> on page 907 default-information-originate [always] [metric value] [metric-type type] on page 908 default-metric <value> on page 909

network <ip address> <wildcard> area <area id> on page 910 redistribute connected on page 911

redistribute rip on page 912 redistribute static on page 913

summary-address <address> <mask prefix mask> not-advertiseon page 914 timers lsa-group-pacing <seconds> on page 915

timers spf <delay> <hold> on page 916

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 903