RAD Data comm IPmux-1E operation manual Bundle Connection Configuration, Yes

IPmux-1/1EInstallation and Operation ManualAppendix E Parameters and Screens

Table E-17. Signaling Profile Configuration (Cont.)

Parameter	Possible Values	Remarks
Tx B	B, B Inverse, 0, 1	Specifies which ABCD Signaling Bit carries the on hook/off hook
		information to the far-end device. One or more can be configured to
		carry the off-hook/on-hook information, while the other bits should
		be set to ‘1’ or ‘0’.
Tx C	C, C Inverse, 0, 1	Specifies which ABCD Signaling Bit carries the on hook/off hook
		information to the far-end device. One or more can be configured to
		carry the off-hook/on-hook information, while the other bits should
		be set to ‘1’ or ‘0’.
Tx D	D, D Inverse, 0, 1	Specifies which ABCD Signaling Bit carries the on hook/off hook
		information to the far-end device. One or more can be configured to
		carry the off-hook/on-hook information, while the other bits should
		be set to ‘1’ or ‘0’.

Note For example, if Rx = A, then all other Rx must be NC. If Rx = A Inverse, then all other Rx must be NC. Tx can be A, B , 0, 1.

Main Menu

↓

2.Configuration

↓

3.Bundle Connection Configuration

VLAN ID and VLAN Priority are configurable only if VLAN Tagging is set to Yes.

E.7 Bundle Connection Configuration

	BUNDLE CONNECTION CONFIGURATION
1.	Bundle ID	1
2.	IP TOS	1
3.	TDM Bytes in Frame	48
4.	Connection Status	Disable
5.	Destination IP Address	0.0.0.0
6.	Next Hop	0.0.0.0
7.	Destination Bundle	1
8.	Jitter Buffer (x10 ∝sec) rounded up 1000 ∝sec steps! 300
9.	VLAN Tagging	YES
A. VLAN Id		EE
B. VLAN Priority		00
ESC. Exit

Select item from the menu.

Figure E-26. Bundle Connection Configuration

Parameters must be configured for each connection. To configure all parameters, first select the bundle ID and then proceed with the parameter configuration.

Bundle Connection Configuration E-25

Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com