Appendix E Parameters and Screens IPmux-1/1E Installation and Operation Manual
E-26 Bundle Connection Configuration
First define the bundle.
Table E-18. Bundle Connection Parameters
Parameter Possible Values Remarks
Bundle ID 1 IPmux-1 has a single bundle, with the number set
at 1
IP ToS 0 to 255 Type of Service – sets the IP ToS field in the IP
frames transmitted by the device.
ToS configuration configures the WHOLE byte, since
different vendors may use different bits to tag
packets for traffic prioritization.
ToS assignment applies to all TDM packets leaving
IPmux-1.
Default configuration: 0
TDM Bytes in Frame 48, 96, 144, 192, 240,
288, 336, 384
Allows you to set the UDP payload length – this
parameter enables reduction of Ethernet throughput
(detailed explanation in Chapter 1).
Default payload: single payload (48)
Connection Status Enable
Disable
Connection enabled
Frames will not be sent from this connection
Destination IP Address IP address of the destination device
Next Hop Use the next hop parameter when the Destination IP
address is not in the device subnet. In such cases the
Ethernet frame is sent to the next hop IP. If it is not
configured, the default gateway is used. Default
value: 0.0.0.0 (not configured)
Note: The next hop IP must be in the device subnet.
Destination Bundle E1: 1 to 496
T1: 1 to 384
Bundle number in the destination device
Jitter Buffer 3 to 300 milliseconds
(ms)
Desired depth of the jitter buffer (PDVT buffer).
Default value: 300 (10 x µs), i.e. 3 msec
VLAN Tagging Yes
No
You must set options 9 and A in the Bundle
Connection Configuration menu
Note: For an explanation of VLAN tagging see
Chapter 1.
VLAN ID 0 to 4095 Default value: 0.
VLAN Priority 0 to 7
Note
Order from: Cutter Networks
Ph:727-398-5252/Fax:727-397-9610
www.bestdatasource.com