IPmux-1/1E Installation and Operation Manual Appendix E Parameters and Screens
General Configuration E-13
➤ To save the parameters and start the transmission process:
• Enter S.
If all parameters are correct, you will be asked for confirmation. After
confirmation, the TFTP session begins. You can view the Transfer Status
(see Figure E-17).
The View Transfer Status values are listed in listed in Table E-10.
Boot code download is not possible using TFTP.
Reboot the system after you have completed TFTP download via X-Modem screens.
VIEW TRANSFER STATUS
Status Transferring Data
Error No Error
Use <Esc> key to Exit
Figure E-17. View Transfer Status Window
Table E-10. View Transfer Status Parameters
Parameter Values Remarks
Status Indication No Operation, Connecting, Transferring Data,
Ended on Time Out, Ended OK, Error
Error Message Unavailable (no host IP), No Error, File Not Found,
Illegal TFTP Operation, Unknown Transfer ID,
Illegal PDU Size, Illegal File Mode, No Empty Connection,
No Empty UDP Port, Server Overflow
Setting Default Parameters reconfigures the device according to default
parameters. Before overwriting the system, the warning in Figure E-18 appears
asking you to confirm your selection.
Configuration will be overwritten and system will RESET.
Continue ? (Y/N)
Figure E-18. Reset Default Warning
Main Menu
↓
2. Configuration
↓
1. General
Configuration
↓
7. Set Default
Parameters
Note
Note
Order from: Cutter Networks
Ph:727-398-5252/Fax:727-397-9610
www.bestdatasource.com