HP 7000 dl Router Frame Relay SUB-INTERFACE Config Command SET, Spanning-tree commands begin on

SROS Command Line Interface Reference Guide Frame Relay Sub-Interface Config Command Set

FRAME RELAY SUB-INTERFACE CONFIG COMMAND SET

To activate the Frame Relay Interface Configuration , enter the interface frame-relaycommand (and specify a sub-interface) at the Global Configuration Mode prompt. For example:

Router>enable

Router#configure terminal

Router(config)#interface frame-relay 1.16

Router(config-fr 1.16)#

The following commands are common to multiple command sets and are covered in a centralized section of this guide. For more information, refer to the sections listed below:

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924 do on page 928

end on page 929 exit on page 930

ping <address> on page 931 show running-configon page 933

All other commands for this command set are described in this section in alphabetical order.

access-policy <policyname> on page 588 backup commands begin on page 591 bandwidth <value> on page 599 bridge-group <group#> on page 600 crypto map <mapname> on page 601 backup commands begin on page 591

dynamic-dns [dyndns dyndns-custom dyndns-static] <hostname> <username> <password> on page 611

ip commands begin on page 617 mtu <size> on page 637

spanning-tree commands begin on page 638

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 587