Zebra Technologies TTP 8000 manual Disable the loop, Cm loop

78

Default Parameter Settings

Print Setup

8	13	Default	Max Print Speed	DRV
	1	Min
	17	Max

The main reason to decrease the print speed is to enhance print quality, and to reduce the peak current consumption. Each step represents a 5 mm/s increase in TTP 8200 and 3.33 mm/s in TTP 8300.

	n	1	2	3	4	5	6	7	8	9	10	11	12	13	14	15	16	17
TTP 8200	mm/s	20	25	30	35	40	45	50	55	60	65	70	75	80	85	90	95	100
TTP 8300	mm/s	13	17	20	23	27	30	33	37	40	43	47	50	53	57	60	63	67

Note • Some settings result in printer chassis resonance causing excessive noise and deteriorated print quality.

9	10	Default	Presenter Loop Length
	3	Min
	255	Max

Limits the maximum loop length. When the set length is reached, the printer ejects part of the printout and continues to print. You use this when you have very limited space for the loop inside the kiosk. Each step represents a 3.2-cm increment.

Setting the parameter to 0 disables the looping and feeds the paper straight out.

<ESC>&P<9><0>	Disable the loop
<ESC>&P<9><7>	16 cm loop
<ESC>&P<9><10>	32 cm loop

13	0	Default	Line Spacing
	0	Min
	255	Max

The line spacing is normally set by the font height. With this parameter you can set a line spacing that is higher that the font height. Line spacing settings lower than the font height will be ignored.

<ESC>&P<13><30>

30 pixels or font height, whichever is the largest

14	0	Default	Font Selection
	0	Min
	7	Max

Store which font number is used if no font is specified. Font is selected using Font Selection on page 78. Selecting an invalid font gives a software error status message (invalid index).

P1003638-003 TTP 8000 Technical Manual 10/19/2009