Zebra Technologies TTP 8000 manual Ejects the presented, Retracts the presented

Programming

Cut and Present Commands

ESC FF n1			Eject (run presenter)
1B	0C n1	hex
27	12 n1	decimal

<ESC><FF><n> ejects the document through the presenter module. Variable n represents the eject-length in steps. The setting of parameter n47 is always added to the eject n in all forms of eject.

The range for n is 1 to 127 mm. The range 128-255 is reserved for future use.

Place this command after a cut command (<ESC><RS>) to partially eject the printout to the customer. Set the eject length so that the customer sees that the printout comes out of the kiosk wall. The pull-detector gives motorized eject of the rest of the printout when the customer pulls the paper.

Note • The cut and eject command <RS>, automatically give the eject length of 50 mm in addition to the factor stored in parameter n47.

Note • The resolution of the sensor is ± 3 mm so small changes in the parameter setting may not show.

Longer ejects are more accurate than shorter ones because acceleration and retardation of the rollers affects the eject less. Allow for ± 10 mm variations on short ejects.

51

EM	n		Enforced Clear Presenter
19	n1	Hex
25	n1	Decimal

Same function as ENQ but overrides the Retract and Retain parameter (p45) with another presenter behavior. The function of n can be 0 to 255 0-99 ejects while 100-255 retracts (see the description of parameter 45). The command will clear the presenter immediately (with printing synchronization).

		<EM><0>	Ejects the presented page
		<EM><100>	Retracts the presented page
ENQ			Clear Presenter
05	Hex
5	Decimal

Clear the paper-path in the presenter of printouts. For example, to eject a document not removed during the previous print/cut/eject operation. Parameter No. 45 controls how the presenter is cleared, see parameter 45 on page 83.

10/19/2009 TTP 8000 Technical Manual P1003638-003