Zebra Technologies TTP 8000 manual Parameters Used, Parameter n34 Auto Cut

90

Page Setup

Parameters Used

Parameters Used

Parameter n34 Auto Cut

When this parameter is set to 2, "forced cut at black mark" The printer always cuts when it detects a black mark, even if no cut command has been received. This prevents long documents from being printed as one continuous printout over several pages.

Parameters n37 and n38 - Page Length Minimum

Measure the distance from the trailing edge of one black mark to the trailing edge of the next. The resolution is 0.1 mm so multiply the distance by 10, then calculate the value to enter as n37 and n38.

Example • If the page length is 200mm, (200 x 10) / 256 = 7.8125.

n37 is the integer value, that is 7, while n38 is the fraction

0.8125 x 256 = 208

Parameter n39 – Max Black Mark Length

Measure the height of the black mark. The resolution is 0.1 mm so multiply the black mark length by 10 and enter the value as n39.

Parameter n40 – Min Black Mark Length (Garbage Filter)

This parameter is actually a filter to filter out garbage on the paper. If a spot is smaller than this value, it will not be regarded as a black mark. 1. About ? of the black mark length is usually a suitable setting.

P1003638-003 TTP 8000 Technical Manual 10/19/2009