Zebra Technologies TTP 8000 manual Erases all fonts stored in the flash Prom

		Programming
		System Related Commands
ESC & 5		Set Default Profile Pointer to n
1B 26 05 n1	hex
27 38 5 n1	decimal

Redirects any parameter storage initiated by <ESC>&<4> to another storage location.

These settings can later be recalled by <ESC>&<F><n>. A reset command or power OFF/ON will return the parameters to the default settings stored in n=10.

53

		n = 1 – 5	Settings that can be stored by the user
		n = 10	Zebra factory default setting
ESC & 0			Load Font
1B 26 00		hex
27 38 0	decimal

This command is used to load a font to the printer flash PROM. The font is placed in the first free address position in the order of load sequence.

A Zebra font-file consists of a header containing data describing the font as well as data for each individual character in the font.

Fonts can be designed with the font editor and loaded or deleted with the software available for download from the Zebra web site. The font loading and deleting commands described here should only be used if you do not work in the Windows environment.

For complete specification of the font format, see Fonts on page 64.

Note • The available font memory is printed on the self-test printout. A maximum of 8 fonts can be addressed. Exceeding any of these limits will cause this command to fail.

ESC & C		Erase all Fonts
1B 26 43	Hex
27 38 67	Decimal

Erases all fonts stored in the flash PROM.

		Note • This command is only executed if at least one font has been loaded.
ESC & D			Erase Fonts 4 to 7
1B 26 44	Hex
27 38 68	Decimal

Erases fonts number 4–7. Fonts 0–3 are not affected by this command.

The operation is complete when the printer resets automatically and activates the presenter motor temporarily. Takes approximately 4 seconds.

10/19/2009 TTP 8000 Technical Manual P1003638-003