Zebra Technologies TTP 8000 manual Fixed Document Mode, Sets max black mark length to 15 mm

82

Default Parameter Settings

Fixed Document Mode

Fixed Document Mode

Max fixed document mode page length depends on the amount of free ram. Make a self test printout to check how much is available in your printer. (Depends on firmware version and circuit board revision).

Page length = Free RAM in bytes −1024 − top margin − bottom margin

Paper width

Paper length, top, and bottom margins are in pixel lines. Paper width is in bytes. 1 byte = 1 mm for the TTP 8200 and one byte is 2/3 of a mm in TTP 8300.

Example • If Free RAM on a TTP 8200 is 504976 bytes, page width is 208 mm = 208 bytes, top margin is 20 mm, and bottom margin 10 mm (20 x 8 =160 and and 10 x 8 = 80 pixel lines):

Page length = 504976 −1024 −160 − 80 = 2182 pixel lines = 272mm 208

If a too large fixed page is specified the printout will be blank from memory full to the cut.

39	50	Default	BM (Black Mark) Length
	16	Min
	160	Max

Specifies the length of the black mark in 0.1-mm steps. Measure the length of the black mark on your paper and enter that value here.

Marks 5 mm longer than this value are interpreted as paper out. The default value of 50 equals 5 mm.

<ESC>&P<39><150>

Sets max black mark length to 15 mm.

40	30	Default	Min BM (Black Bark) Length “Garbage Filter”
	5	Min
	159	Max

Specifies the minimum length of the black mark in 0.1-mm steps. Shorter marks are ignored. The default value of 30 equals 3 mm.

<ESC>&P<40><40>

Sets min black mark length to 4 mm.

41 & 42	0	, 0	Default	BM (Black Mark) Cut Offset
	0	, 0	Min
	255	, 255	Max

Defines the paper feed between the black mark detection and cut. One step is 0.1 mm.

<ESC>&P<41><1><ESC>&P<42><244>

Feeds 50 mm between black mark and cut.

P1003638-003 TTP 8000 Technical Manual 10/19/2009