Zebra Technologies Automatic Distance Calculation, Feed 2 mm, TTP 8000 series, No indication

				Default Parameter Settings
				Fixed Document Mode
	1	Default
49			Bottom Margin	DRV
	0	Min
	1	Max

Selects if the cut command cuts at the position where the paper is at, or if the printer should advance the paper before cutting.

85

<ESC>&P<49><0>	Off
<ESC>&P<49><1>	Automatic Distance Calculation
<ESC>&P<49><2>	Feed 2 mm
<ESC>&P<49><255>	Feed 255 mm "Automatic Distance
	Calculation" means advancing the paper
	with the Head-To-Cutter distance (19 mm on
	the TTP 8000 series).

Set to 1 if the printer is used in text mode and 0 if it is used from a driver that takes care of this in the driver.

Note • The paper is advanced before the FF command calculates the page length to see if the page length is longer than the set minimum length.

51	50	Default	Black Mark Sensitivity
	0	Min
	255	Max

This parameter is used by command ESC # to store the calibration of the black mark sensor. Normally there is no need to set this parameter manually.

0 is white and 255 is pitch black (out of paper).

Note • This parameter is not available on printers with hardware revision A of the control board. The revision is printed on the test printout.

52	0	Default	Warning Level
	0	Min
	255	Max

Turns on/off indication of Paper Near End and Weekend paper level on the status indicator (Figure 3, Printer Exterior, Rear View, on page 11) . This affects only the status indicator, not the status enquiries.

<ESC>&P<52><0>	No indication
<ESC>&P<52><1>	Paper Near End indication
<ESC>&P<52><2>	Weekend level indication
<ESC>&P<52><3>	Paper near end and weekend indication

10/19/2009 TTP 8000 Technical Manual P1003638-003