Zebra Technologies TTP 8000 manual N41, n42 N39, Printable Area

88 Page Setup

Printable Area

Printable Area

n41, n42

n39				5.2.2			Text commands
						Text received by the printer is printed with the currently selected font and font attributes.
						Text exceeding the page width is wrapped with the line spacing selected.
		ESC	o		n
Black Mark						Changes the orientation of text and logotypes.
						n = 0	Gives portrait orientation
						n = 1	Gives landscape orientation
on back of						Portrait and landscape can be mixes on the same printout. There are two cursors, one for
						portrait and one for landscape. The cursor always starts at the top left corner of the
						document. Looking at the paper when it exits the printer, the portrait cursor is at the top
						left corner of the printout, moving to the right as text is typed, while the landscape cursor
page						is at the top right corner, moving downwards.
						NOTE! — Landscape orientation can only be used with fixed page length. The max page
						length for landscape orientation is A5-size, which is 148.5 mm.
		ESC	!		n
						This command selects one of eight fonts. The font design depends on which fonts have
						been loaded into the printer. Make a test printout to see which fonts are available in your
						printer.
						ESC !	0 selects normal font (font 0)		ESC !	4 selects font 4
						ESC !	1 selects font 1		ESC !	5 selects font 5
						ESC !	2 selects font 2		ESC !	6 selects font 6
						ESC !	3 selects font 3		ESC !	7 selects font 7
								Table 4. Font selection commands
						"GLines, too long to be printed in the selected font, are automatically wrapped around.
						"GDifferent fonts can be used on the same line.
						"GSelection of an erased or for any other reason non-existent font, will set bit 4 of byte 1 in
						the status enquiry response to ”1". See “Parameter setting data enquiry” on page 45.
						NOTE! — If more than 256 characters are sent to the printer before an LF,
						the first part of the buffer contents is printed-out automatically. The text is
						formatted according to the already received formatting commands.
		For font loading, see "System related commands" on page 38
	0308							TTP 8x00 Kiosk Printer –Technical Manual			27
								n48

n43, n44

n37, n38

n49

P1003638-003 TTP 8000 Technical Manual 10/19/2009