Zebra Technologies TTP 8000 manual Set several parameters at once

54

Programming

System Related Commands

ESC & F n1		Reset Parameter Profile
1B 26 46 n1	Hex
27 38 70 n1	decimal

This command resets the parameters of the printer to default or any previously stored setup.

n = 1 – 5	Settings that can be stored by the user
n = 10	Zebra factory default setting

Temporarily sets all parameters to predefined values that are stored in the printer. To keep the values as default, store them in the flash PROM with command <ESC>&<4>.

Unless you save the parameters, a reset command or power OFF/ON will return the parameters to the settings stored in the flash PROM.

ESC & P n1...n2		Set Parameter Value
1B 26 50 n1...n2	hex
27 38 80 n1...n2	decimal

A number of bytes in the flash PROM hold various parameter values called default parameters. One or several of them can be overridden temporarily with this command.

n1	Parameter number, range 1 -255.
n2	Parameter value.

See Default Parameter Settings on page 71.

The permanently stored parameters will be used again after a printer-reset command or at power ON.

The temporary values can, however, be stored in the flash PROM as permanent values with command <ESC>&<4>.

Set several parameters at once

<ESC>&P<0><FromPar><ParCount><Data>

FromPar is the parameter number to start writing and ParCount is the number of bytes being sent. For every byte sent the parameter number is incremented.

Example • Sets the first 5 tabs to 5, 10, 15, 20, and 25. (FromPar 15, ParCount 5).

<ESC>&P<0><15><5><5><10><15><20><25>.

P1003638-003 TTP 8000 Technical Manual 10/19/2009