Zebra Technologies TTP 8000 manual Summary of Parameter Settings

				Default Parameter Settings
				How the Parameters are Described
	Table 10 • Summary of Parameter Settings
Parameter	Description	ESC&F <10> Default			Page
1	Baud rate	96		(9600 Baud)	page 74
2	Data bits	8			page 74
3	Parity	0	(No parity)		page 74
4	Flow control	2	(Hardware)		page 75
5	Disable parallel port signaling	0	(No)		page 76
6	Buffer mode	0	(Spool all data before printing)		page 77
7	Burn time	14			page 77
8	Print speed	13		(80mm/s for 203 dpi, 53mm/s for 300 dpi)	page 78
9	Presenter loop length	10		(32 cm)	page 78
13	Line spacing	0	(Auto)		page 78
14	Font selection	0	(TTP Mono 9)		page 78
15 to 30	Tab stop	4, 8, 12 etc.			page 79
31	Pull speed	20		(1 on the vertical version of TTP 8200)	page 79
33	CR/LF	0	(LF = CR/LF, CR=Ignored)		page 79
34	Auto cut after FF	1	(On)		page 80
36	Document mode	1	(Variable)		page 80
37 & 38	Page length, Minimum / fixed / BM	4, 0 (102.4 mm)			page 81
39	Max black mark length	50		(5 mm)	page 82
40	Min black mark length	30		(3 mm)	page 82
41 & 42	Black mark cut offset	0, 0 (0 mm)			page 82
43 & 44	Top margin	0, 0 (Disabled)			page 83
45	Wastebasket	3	(Eject and retract after 30 s)		page 83
47	Wall Compensation	0			page 84
48	Paper width	208 mm			page 84
49	Bottom margin	1	(Auto)		page 85
51	Black mark level	50		(0.97 V)	page 85
52	Warning level	0	(Off)		page 85
53	Lock parameters	0	(Unlocked)		page 86
55	PSU recovery	255			page 86

73

Note • When the printer is set up the way you like it to be, you send <ESC>&<4>, and all settings will be stored.

10/19/2009 TTP 8000 Technical Manual P1003638-003