Zebra Technologies TTP 8000 manual Cut and Present Commands, To auto, see parameter 49 on

50

Programming

Cut and Present Commands

Cut and Present Commands

RS		Cut and Eject
1E	Hex
30	Decimal
		Effects a paper cut-off and an eject through the presenter module. The RS command
		automatically gives the eject length of 50 mm in addition to the factor stored in parameter p47.
		If the printout length is too short, paper-feed is added until the minimum printout length (set by
		parameters 37 and 38) is reached, before execution of the Cut command.
		Note • The cut position is 19 mm before the print line. This makes the last 5 lines on a page
		end up in the beginning of the next page. To get the cut after the text, Please set parameter 49
		to auto, see parameter 49 on page 85.
		You can also use <RS> together with the paper advance command:
		<ESC>J<160><RS> or <ESC>J<230><RS> for TTP 8300.
		Gives a cut & eject after the last text line.
ESC RS		Cut only, no Eject
1B 1E	Hex
27 30	Decimal

Effects paper cut-off only.

Eject can be effected with the <ESC><FF><n> command (see Eject (run presenter) on page 51).

To avoid thin strips of paper in the printer, multiple cut commands without paper feed in- between will not be performed. If the printout length is too short, paper-feed is added until the minimum printout length is reached, before execution of the cut command.

See Also Note on cut position for the <RS> command above.

Note • Use the cut command if you want full control over the printer from your system. But remember that you also must add commands to feed to the correct cut position and eject the paper so that the customer can get hold of it.

Note • Top margin settings that move the paper count as paper feed.

P1003638-003 TTP 8000 Technical Manual 10/19/2009